BatiBUS
Network protocol for building automation
BatiBus was a network protocol for building automation that was introduced in 1989 and has since been succeeded by KNX. It was a relatively simple low-cost protocol that did not rely on dedicated chips.
The system was run by the BatiBus Club International (BCI), which was founded by the Swiss company Landis & Gyr and the French companies AIRELEC, Electricité de France and Merlin Gerin (who originated the concept). Predominantly used in France and captured by French Electrical Standard NF C 46620, it provided layers 1, 2 and 7 of the OSI model. Approximately 500,000 BatiBus network units were installed, mainly in France.
BatiBus communicated over twisted pair lines and in topologies that could be divided into several segments. Each segment was powered with a 15 volt power supply rated at 150 milliamps. A device (node) could be reached at one of 240 possible addresses. In addition, 16 group addresses could be established under which all nodes in a group could be reached. The nodes avoided data collisions via CSMA/CA and had data flow controls. The maximum data transfer rate was 4800 bits/s.
Sources and credits
This article is adapted from the Wikipedia article “BatiBUS”, written by its contributors and licensed under CC BY-SA 4.0. Fathomly has changed the layout, removed citation markers, navigation and maintenance notices, and adjusted punctuation. This adapted version is shared under the same license. For references, see the original article.
Fathomly is not affiliated with or endorsed by the Wikimedia Foundation. Spotted a problem? Tell us.